Cisco S195 Посібник для початківців - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник для початківців для Сервер Cisco S195. Cisco S195 18 сторінок. Web security appliance
Також для Cisco S195: Посібник (24 сторінок), Посібник з встановлення обладнання (50 сторінок)
Друкувати сторінку
Run the System Setup Wizard
Log In to the Appliance Using the CLI
Access the CLI locally or remotely:
Step 1
•
•
Log in as admin with the password ironport.
Step 2
At the prompt, enter the systemsetup command.
Step 3
Run the System Setup Wizard
Run the System Setup Wizard to configure basic settings and enable a set of system defaults. The System
Setup Wizard starts automatically when you access the appliance through the web-based interface and
displays the end user license agreement (also known as the EULA).
Accept the end user license agreement.
Step 1
Enter information from the
Step 2
If you need additional information about the settings, choose Help and Support > Online Help.
Step 3
Review the configuration summary page.
Click Install this Configuration.
Step 4
Step 5
The appliance may not appear to have accepted your configuration or be performing the installation. This
is because you have changed the IP address, but the installation is underway.
Step 6
If you temporarily changed the IP address of your computer as described above, change the IP address
settings back to the original values.
Ensure that your computer and the appliance are connected to the network.
Step 7
Step 8
Log in to the appliance again, at the hostname or IP address that you noted in the
section on page
The Cisco Web Security Appliance uses a self-signed certificate that may trigger a warning from your
web browser. Accept the certificate and ignore this warning.
Be sure to keep your new administrator password in a safe place.
Step 9
Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide
14
To access the CLI locally, set up a terminal to connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control set to Hardware. To physically connect the
terminal, see the
"Connect to the Appliance" section on page
To access the CLI remotely, initiate an SSH session to the IP address 192.168.42.42.
"Document Network Settings" section on page
5. Use the username admin and the new password that you entered in the wizard.
7).
2.
"Plan the Installation"