B2 Audio OSPREYD19 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач B2 Audio OSPREYD19. B2 Audio OSPREYD19 14 сторінок.

Strapped control panel setting / speaker wiring

The Falcon / The Osprey

Speaker impedance 2 Ohm ~ 8 Ohm

will reach thermal at a faster rate & will eventually go into protect.

Impedance load under 2 ohm is not warranted in strapped mode!

Step 1. Connect RCA from Head Unit / output source into master

If only one output is available, then use a Y-split to connect both L & R.

Step 2. Locate the Master / Slave switch on the right side of the control panel on the Master

Set the switch to Master position.

step 3. Connect a single RCA from the RCA OUT on the master

Step 4. Locate the Master / Slave switch on the right side of the control panel on the Slave

Set the switch to Slave position.

Step 5. Connect the single RCA cable from the Master

strapped speaker connection

step 1.

Run the

positive (+)

speaker cable from the

positive terminal (+)

of the subwoofer.

step 2.

Run the

speaker cable from the

positive (+)

of the subwoofer.

negative terminal (-)

Step 3.

to negative speaker output on slave

Rca out to the slave

master

slave

negative speaker output on master

RCA IN.