Cisco SNS-3415 series Посібник з встановлення - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з встановлення для Сервер Cisco SNS-3415 series. Cisco SNS-3415 series 19 сторінок. Sns-3400 series
Також для Cisco SNS-3415 series: Посібник з монтажу (36 сторінок), Посібник з усунення несправностей (8 сторінок)
Друкувати сторінку
Chapter 8
Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
Figure 8-5
1
Using the BIOS Recovery Header J41
Depending on which stage the BIOS becomes corrupted, you might see different behavior.
•
•
Service Header Locations
FAN1
FAN2
FAN3
FAN4
FAN4
FAN5
J41 BIOS RCVR BOOT
If the BIOS BootBlock is corrupted, you might see the system get stuck on the following message:
Initializing and configuring memory/hardware
If it is a non-BootBlock corruption, the following message is displayed:
****BIOS FLASH IMAGE CORRUPTED****
Flash a valid BIOS capsule file using CIMC WebGUI or CLI interface.
IF CIMC INTERFACE IS NOT AVAILABLE, FOLLOW THE STEPS MENTIONED BELOW.
1. Connect the USB stick with recovery.cap file in root folder.
2. Reset the host.
IF THESE STEPS DO NOT RECOVER THE BIOS
1. Power off the system.
2. Mount recovery jumper.
3. Connect the USB stick with recovery.cap file in root folder.
4. Power on the system.
Wait for a few seconds if already plugged in the USB stick.
REFER TO SYSTEM MANUAL FOR ANY ISSUES.
Connecting and Powering On the Cisco SNS-3415/3495 Appliance
CPU1
CPU2
3
2
1
2
J37 Clear CMOS
Installation and Upgrade Guide for Cisco Secure Access Control System 5.6
PCIe1
PCIe2
PSU2
PSU1
8-15