Cisco SNS-3415 series Посібник з монтажу - Сторінка 30

Переглянути онлайн або завантажити pdf Посібник з монтажу для Сервер Cisco SNS-3415 series. Cisco SNS-3415 series 36 сторінок. Sns-3400 series
Також для Cisco SNS-3415 series: Посібник з встановлення (19 сторінок), Посібник з усунення несправностей (8 сторінок)

Cable Management

You can connect the keyboard and video monitor to the Cisco SNS-3415 or Cisco SNS-3495 appliance using

the KVM connector available in the front panel of the Cisco SNS-3415 or Cisco SNS-3495 appliance. A KVM

cable is shipped along with the appliance that provides two USB, one VGA, and one serial connector.

The Cisco SNS-3415 or Cisco SNS-3495 appliance does not provide support for a mouse.

The Cisco SNS-3415 or Cisco SNS-3495 provides USB ports on the rear of the appliance that can be used to

connect a keyboard and video monitor.

To connect a keyboard and video monitor to the appliance:

Step 1

Verify that the appliance is turned off.

Step 2

Connect the end of the keyboard cable to the PS/2 (keyboard) port which is located on the back panel of the appliance.

Step 3

Connect the end of the video monitor cable to the PS/2 (video monitor) port which is located on the back panel of the

appliance.

Step 4

Power on the appliance.

Cable Management

Cable management is the most visual aspect of your appliance setup. However, cable management is often

overlooked because it can be time consuming.

Equipment racks and enclosures house more equipment today than ever before. This growth has increased

the need for organized cable management both inside and outside the rack. Poor cable management not only

leads to damaged cables or increased time for adding or changing cables, but also blocks critical airflow or

access. These problems can lead to inefficiencies in the performance of your equipment or even downtime.

There are many solutions to address cable management. They can range from simple cable management rings,

to vertical or horizontal organizers, to troughs and ladders.

All Cisco SNS-3415 or Cisco SNS-3495 appliance cables should be properly dressed so as not to interfere

with each other or other pieces of equipment. Use local practices to ensure that the cables attached to your

appliance are properly dressed.

Proceed to the next section,

continue the installation process.

•

Cisco SNS-3400 Series Appliance Hardware Installation Guide

Connect and Power On the Cisco SNS 3415 or 3495 Appliance, on page

Connect and Power On the Server (Standalone Mode), on page 27

NIC Modes and NIC Redundancy Settings, on page 28

System BIOS and CIMC Firmware, on page 29

Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

26, to