Epson ES-300GS Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Epson ES-300GS. Epson ES-300GS 5 сторінок. Personal document station grayscale scanner
Також для Epson ES-300GS: Початок роботи (16 сторінок)
Друкувати сторінку
EPSON ES-300GS
Connector type:
Signal pin assignments
In this table, the direction of the signals is given relative to
the scanner.
Initialization
The scanner
be initialized (returned to a fixed set of
can
conditions) in the following ways.
Hardware initialization:
interface (pin 31 goes low).
interface.
Software initialization:
scanner) is received.
EPSON ES-300GS-4
Problems and Solutions
involve the operation of your software and computer.
Problems fall in the following major categories:
Also see the documentation that came with your software
and computer for possible solutions.
Indicator lights
If an error occurs, the scanner stops operating and the
and
Ready
Error lights
Error type
on
Flashing
Fatal emor
Command error
The scanner has received incorrect commands from your
scanning software. When this error occurs, retry the scanning
operation. The scanner returns to normal operation when it
receives correct commands. Normally you do not need to
scanner, which is done by turning the scanner off
reset the
and then on.
damage the scanner.
Interface error
The scanner may not be properly connected to the computer.
Check the interface
and back on to reset it.
The interrupt settings or the port addresses for the interface
board
be set correctly or may conflict with
may not
installed expansion boards.
4/96
show the type of error.
on
Flashing
flashing
Scanners