finder 19.6K Посібник - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник для Контролер finder 19.6K. finder 19.6K 17 сторінок. Knx actuator
Друкувати сторінку
1.11.3 PAR_Enable Storage for Scene Y
•
Property Datatype: PDT_UNSIGNED_8bit
•
Datapoint Type: enumerated
•
Range: [0÷1]
It enables or disables the scenario overwriting. Default value 0 means disabled, while 1 enabled. If enabled,
the channel actual status will be stored on the device by sending the DPT_Channel X
message.
1.12 Detailed description of the general configuration parameters
These parameters are common to all channels.
1.12.1 PAR_Value Force ALL Out
•
Property Datatype: PDT_UNSIGNED_8bit
•
Datapoint Type: none
•
Range: [0÷1]
Value at which all outputs will be forced with highest priority.
1.12.2 PAR_Enable Keyboard
•
Property Datatype: PDT_UNSIGNED_8bit
•
Datapoint Type: none
•
Range: [0÷1]
It enables or disables the keypad for manual control of channels on testing phase. Once the device has been
after which the yellow LED blinks to indicate test is in progress. To exit test mode briefly press the TEST
button. During test mode in progress, the channel relay switches by pressing the corresponding channel key.
The green LED turns ON or OFF any time channel switches according to Table 5. During test mode in progress
(yellow LED blinking) all telegrams received from the device to command a channel switching will not take
effect and shall be resend after completing the test.
1.13 Behavior of Channel LED
The led reflects the channel status, so it turns on if status is ON, and turns off if status is OFF. The table below
summarizes the correspondence led/relay condition.
Led status
On
Off
(*) The status of the relay contacts will depend on the setting of the Par_Contact Type parameter, if is set on
NC, the configuration results inverted.
FINDER SpA
Ver. 2018
)
(*)
Relay condition
Relay is in ON condition
Relay is in OFF condition
Table 5
KNX Actuator 19.6K
Select Scene
16