Cisco UCS B460 M4 Вказівки щодо встановлення та обслуговування - Сторінка 20

Переглянути онлайн або завантажити pdf Вказівки щодо встановлення та обслуговування для Сервер Cisco UCS B460 M4. Cisco UCS B460 M4 46 сторінок. Blade server
Також для Cisco UCS B460 M4: Технічний паспорт (7 сторінок), Посібник із швидкого старту (2 сторінок), Посібник із швидкого старту (5 сторінок), Вказівки щодо встановлення та обслуговування (50 сторінок)

Powering Off a Blade Server

You can also shut down servers remotely using Cisco UCS Manager or CIMC. For details, see the

Tip

Configuration Guide for the version of Cisco UCS Manager that you are using. The configuration guides

are available at the following URL:

and_configuration_guides_list.html

Procedure

Step 1

If you are local to the server, check the color of the Power Status LED for each server in the chassis that you

want to power off.

• Green indicates that the server is running and must be shut down before it can be safely powered off.

• Amber indicates that the server is already in standby mode and can be safely powered off. Go to Step

Step 2

If you previously enabled front power button control through Cisco UCS Manager, press and release the

Power button, then wait until the Power Status LED changes to amber. Otherwise, you cannot press the front

power button because it is disabled by default.

The operating system performs a graceful shutdown and the server goes to standby mode.

Caution

Step 3

(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis

to completely power off the servers.

Step 4

Remove the appropriate servers from the chassis.

You must power off the blade server or decommission it using Cisco UCS Manager before physically removing

the blade server from the chassis.

Procedure

Step 1

Turn off the blade server using either Cisco UCS Manager or the power button.

Step 2

If you are removing a UCS B460 M4 blade server, completely loosen the captive screws on the UCS Scalability

Connector and remove the connector by pulling it away from the two UCS B260 blade modules. If you are

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Go to Step 2.

To avoid data loss or damage to your operating system, you should always invoke a graceful

shutdown of the operating system.

http://www.cisco.com/en/US/products/ps10281/products_installation_

Installing a Blade Server