Cisco UCS C220 M3 Посібник з конфігурації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з конфігурації для Сервер Cisco UCS C220 M3. Cisco UCS C220 M3 33 сторінки. Security manager 4.3
Також для Cisco UCS C220 M3: Посібник із швидкого старту (29 сторінок), Посібник з оновлення (10 сторінок), Посібник із швидкого старту (12 сторінок)
RAID 0
RAID 0 provides disk striping across all the drives in the RAID drive group. RAID 0 does not provide any data
redundancy, but it offers the best performance of any RAID level. RAID 0 divides data into smaller segments and
then stripes the data segments across each drive in the drive group. The size of each data segment is determined
by the stripe size. RAID 0 offers high bandwidth.
RAID 0 is excellent for applications that require high bandwidth but do not require fault tolerance. Table 1 provides
an overview of RAID 0. Figure 2 shows an example of RAID 0 use.
Table 1.
RAID 0
Uses
Ÿ
Advantages
Ÿ
Limitations
Ÿ
Drives
Figure 2.
RAID 1
In RAID 1, the RAID controller duplicates all the data from one drive to a second drive in the drive group. RAID 1
supports an even number of drives from 2 through 32 in a single span. It provides complete data redundancy, but
at the cost of doubling the required data storage capacity.
RAID 1 is excellent for environments that require fault tolerance and have small capacity. Table 2 provides an
overview of RAID 1. Figure 3 shows an example of RAID 1 use.
Table 2.
RAID 1
Uses
Advantages Provides complete data redundancy
Limitations
Drives
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
RAID 0
● Provides high data throughput, especially for large files
● Good for any environment that does not require fault tolerance
● Provides increased data throughput for large files
● No capacity loss penalty for parity
● Does not provide fault tolerance or high bandwidth
● All data is lost if any drive fails
1 through 32
RAID 0 Drive Group with Two Drives
RAID 1
Good for small databases or any other environment that requires fault tolerance but has low
capacity
Requires twice as many drives
2 through 32 (must be an even number of drives)
Page 4 of 33