Cisco UCS E Series Посібник з усунення несправностей - Сторінка 21
Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Сервер Cisco UCS E Series. Cisco UCS E Series 28 сторінок. Ucs e series unified computing system
Також для Cisco UCS E Series: Огляд продукту (8 сторінок), Посібник з монтажу (46 сторінок)
Друкувати сторінку
Overview
SUMMARY STEPS
1. In the Navigation pane, click the Server tab.
2. On the Server tab, click RAID. The Storage Card page appears.
3. Click the Controller Info tab.
4. In the Settings area, the current boot drive information is displayed in the Current Boot Drive field.
DETAILED STEPS
Step 1
In the Navigation pane, click the Server tab.
Step 2
On the Server tab, click RAID. The Storage Card page appears.
Step 3
Click the Controller Info tab.
Step 4
In the Settings area, the current boot drive information is displayed in the Current Boot Drive field.
Mouse and Keyboard Use in LSI WebBIOS Flaky
This is a known problem. To work around this problem, connect a physical mouse and keyboard.
When to Use LSI WebBIOS
This section is applicable to E-Series Servers and the SM E-Series NCE. This section is not applicable to
Note
the EHWIC E-Series NCE.
Use the LSI WebBIOS under the following conditions:
• When the LSI warning message appears at OPROM, which requires drive configuration.
• To configure RAID arrays with SED drives.
• To change or remove security keys and pass phrase for SED.
• To configure foreign SED drives.
• To clear RAID configuration before installing a new operating system.
Show Inventory Command Output Displays Unknown xxx Error Message
This error message is applicable to E-Series Servers and the SM E-Series NCE. This error message is not
Note
applicable to the EHWIC E-Series NCE.
Symptom—When you enter the show inventory command, the server is not recognized and you get the
following error message:
Router> show inventory
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
Storage Troubleshooting
21