Cisco 3700 series Встановлення та форматування - Сторінка 14

Переглянути онлайн або завантажити pdf Встановлення та форматування для Шлюз Cisco 3700 series. Cisco 3700 series 34 сторінки. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Також для Cisco 3700 series: Інструкції з оновлення (30 сторінок), Технічний паспорт (8 сторінок), Примітка до заявки (41 сторінок), Посібник з монтажу (12 сторінок)

Друкувати сторінку

Cisco 3700 series Встановлення та форматування

Internal CompactFlash Memory Card Installation and Removal

Place the removed CompactFlash memory card on an antistatic surface or in a static shielding bag.

Step 4

Installing an Internal CompactFlash Memory Card

Cisco 2691 routers, Cisco 3631 routers, and Cisco 3700 series routers have an internal connector for a

Compact Flash memory card. You can install a CompactFlash memory card with 32-, 64-, or 128-MB of

memory.

Complete the following steps to install an internal CompactFlash memory card:

Locate the CompactFlash memory-card connector on the CPU/mainboard. (See

Step 1

Figure

Insert the connector end of the CompactFlash memory card into the connector until the card is seated in

Step 2

the connector. The card is keyed so that it cannot be inserted incorrectly.

If there was a retention screw, reinstall it in the standoff.

Step 3

Install the plug-in CPU/mainboard or the chassis cover as described in the

Step 4

CPU/Mainboard" section on page 14

page

Step 5

Refer to the

instructions on formatting the CompactFlash memory card.

Reinstalling a Plug-in CPU/Mainboard

This section describes how to reinstall a plug-in CPU/mainboard. You need a number 2 Phillips

screwdriver or flat blade screwdriver to complete this procedure:

Place the chassis so the empty CPU/mainboard slot faces you.

Step 1

Make sure that the ejector levers are fully open. Carefully insert the CPU/mainboard into the chassis

Step 2

slot until the connector is engaged, then close the ejector levers to fully seat the CPU/mainboard

connector. (See

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

6, or

Figure

7.)

16.

"Formatting Procedures for CompactFlash Memory Cards" section on page 20

Figure

13.)

or the

"Reinstalling the Cover on a Cisco Router" section on

March 2002

Figure

"Reinstalling a Plug-in

for

78-13892-03