Cisco 3G MicroCell Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Шлюз Cisco 3G MicroCell. Cisco 3G MicroCell 20 сторінок. At&t wireless network gps signal extender
Також для Cisco 3G MicroCell: Посібник користувача (20 сторінок), Посібник із швидкого старту (8 сторінок), Посібник користувача (20 сторінок)
Друкувати сторінку
Option B
AT&T 3G MicroCell™
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1.
Disconnect
your current
on the 3G MicroCell.
2. Take the
yellow Ethernet cable
labeled
`Ethernet'
on the 3G MicroCell and the other end to the
3. First,
turn off power
equipment in the following order:
a) Modem
b) 3G MicroCell
(Do this last
the 3G MicroCell and connect the other end to an
10
High Speed Internet with Modem Attached to Computer
1
2
3
Power
Connect AC power adapter last.
Note: If you normally use a USB cable to connect to your modem and computer,
refer to 'Connect Your Devices with USB Cables?' on page 8 for cabling alternatives.
Ethernet cable from the modem
that came with the 3G MicroCell and connect one end to the yellow port
to your current internet equipment.
– connect one end of the
This end is attached
to your computer.
Do NOT unplug.
2
Ethernet Cable
(Included)
and reconnect it to the black port labeled
Ethernet port on your
Wait 1
minute, then
turn on power
AC Power Adapter
to the port labeled
AC
outlet.)
Advance to page 12.
Open Port
Modem
`Computer'
port
modem.
to your Internet
'Power'
on