Cisco AT&T 3G MicroCell Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Шлюз Cisco AT&T 3G MicroCell. Cisco AT&T 3G MicroCell 20 сторінок. Wireless signal booster
Також для Cisco AT&T 3G MicroCell: Посібник для початківців (11 сторінок), Посібник користувача (20 сторінок), Посібник із швидкого старту (8 сторінок)
Друкувати сторінку
Option A
AT&T 3G MicroCell™
Note: Since you have a gateway or Wi-Fi router, you will NOT need to plug anything into the black port labeled 'Computer' on the 3G MicroCell.
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1. Take the
yellow Ethernet cable
'Ethernet'
on the 3G MicroCell.
2. Connect the other end of the
3. First,
turn off power
in the following order:
a) Gateway or Modem
b) Wi-Fi Router (if you have one)
c) 3G MicroCell
(Do this last
the 3G MicroCell and connect the other end to an
High Speed Internet with Gateway or Modem and Wi-Fi Router
Ethernet Cable
1
3
Power
Connect AC power adapter last.
that came with the 3G MicroCell and connect one end to the yellow port
yellow Ethernet cable
to your current internet equipment.
– connect one end of the
(Included)
2
to any open
Ethernet port on your gateway or Wi-Fi
Wait 1
minute, then
AC Power Adapter
AC
outlet.)
Gateway or Wi-Fi Router
Open Ports
turn on power
to your Internet equipment
to the port labeled
'Power'
Advance to page 12.
port labeled
router.
on
9