Digitus professional DN-80065 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач Digitus professional DN-80065. Digitus professional DN-80065 8 сторінок. 8-port gigabit ethernet switch

Друкувати сторінку

Use the screws provided with the equipment rack to mount the Switch on the rack

and tighten it.

3.1.3 Power on the Switch

The Switch is powered on by the AC 100-240V 50/60Hz internal high-performance power

supply. Please follow the next tips to connect:

AC Electrical Outlet: It is recommended to use single-phase three-wire receptacle with

neutral outlet or multifunctional computer professional receptacle. Please make sure to

connect the metal ground connector to the grounding source on the outlet.

AC Power Cord Connection: Connect the AC power connector in the back panel of the

Switch to external receptacle with the included power cord, and check the power indicator

is ON or not. When it is ON, it indicates the power connection is OK.

3.2 Connect Computer (NIC) to the Switch

Please insert the NIC into the computer, after installing network card driver, please

connect one end of the twisted pair to RJ-45 jack of your computer, the other end will be

connected to any RJ-45 port of the Switch, the distance between Switch and computer is

around 100 meters. Once the connection is OK and the devices are power on normally,

the Link/ACT status indicator lights corresponding ports of the Switch.