Cisco Firepower 1600 Посібник з встановлення обладнання - Сторінка 34

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Шлюз Cisco Firepower 1600. Cisco Firepower 1600 44 сторінки.

Rack-Mount the Chassis

The rack must be of the following type:

• A standard 19-in. (48.3-cm) wide, 4-post EIA rack with mounting posts that conform to English universal

• The rack post holes can be square 0.38-in. (9.6 mm), round 0.28-in. (7.1 mm), #12-24 UNC, or #10-32

• The minimum vertical rack space per chassis must be 1 RU, equal to 1.75 in. (44.45 mm).

• The slide rails for the chassis have an adjustment range of 24 to 36 in. (610 to 914 mm).

Note

The slide rails supplied by Cisco Systems for the chassis do not require tools for installation if you install

them in a rack that has square 0.38-in. (9.6 mm), round 0.28-in. (7.1 mm), or #12-24 UNC threaded holes.

Before you begin

Take note of the following warning:

Warning

Statement 1006—Chassis Warning for Rack-Mounting and Servicing

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to

ensure that the system remains stable. The following guidelines are provided to ensure your safety:

• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the

• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the

Step 1

Attach the inner rails to the sides of the chassis:

a) Align an inner rail with one side of the chassis so that the three keyed slots in the rail align with the three pegs on the

side of the chassis.

b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot

has a metal clip that locks over the front peg.

c) Install the second inner rail to the opposite side of the chassis.

Figure 30: Attach the Inner Rail to Side of Chassis

Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide

hole spacing per section 1 of ANSI/EIA-310-D-1992.

UNC when you use the supplied slide rails.

heaviest component at the bottom of the rack.

unit in the rack.

Mount and Connect