Epson Perfection 4990 Series Посібник користувача - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Epson Perfection 4990 Series. Epson Perfection 4990 Series 41 сторінка. Product support bulletin(s)
Також для Epson Perfection 4990 Series: Інформаційний посібник про продукт (6 сторінок), Бюлетень підтримки продукту (11 сторінок), Бюлетень підтримки продукту (5 сторінок), Бюлетень підтримки продукту (12 сторінок)

■

This product includes a lamp that contains mercury (Hg). Please consult your state/

province and local regulations regarding disposal or recycling. Do not put it in the

trash.

■

If you are not going to use the scanner for a long period, be sure to unplug it from the

electrical outlet.

■

Unplug the scanner and refer servicing to qualified service personnel under the

following conditions:

If the power cord or plug is damaged; if liquid has entered the scanner; if the scanner

has been dropped or the case damaged; if the scanner does not operate normally or

exhibits a distinct change in performance. (Do not adjust controls that are not

covered by the operating instructions.)

FCC Compliance Statement

For United States Users

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio or

television reception. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to radio and television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

■

Consult the dealer or an experienced radio/TV technician for help.

WARNING: The connection of a non-shielded equipment interface cable to this

equipment will invalidate the FCC Certification of this device and may cause interference

levels which exceed the limits established by the FCC for this equipment. It is the

responsibility of the user to obtain and use a shielded equipment interface cable with this

device. If this equipment has more than one interface connector, do not leave cables

connected to unused interfaces. Changes or modifications not expressly approved by the

manufacturer could void the user's authority to operate the equipment.

For Canadian Users

This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

Notices