Acuity Brands Lithonia KAXW LED Інструкція з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Зовнішнє освітлення Acuity Brands Lithonia KAXW LED. Acuity Brands Lithonia KAXW LED 4 сторінки.
Друкувати сторінкуInstallation Instructions
KAXW LED
7. Using the provided ¼-20 socket
head cap screws, secure fixture in
place (figure c). Be sure to adjust
fixture vertical position as required
to account for any mounting sur-
face abnormalities before tighten-
ing (80-85 in-lbs).
8. Make supply wire (power and dim-
ming) to fixture wire connections as
required thru splice access.
9. Secure splice access cover in place
using provided 10-24 socket head
cap screws (40-50 in-lbs).
1.
Verify that supply power is off . Using a contractor level, ensure the wall mount plate is level and mark mounting surface
thru selected auxiliary mounting holes. Set the wall mount plate aside.
2.
Drill holes as marked in step 1 and install appropriate mounting inserts capable of handling fixture load requirements.
3.
Feed supply wires thru the center of the wall mount plate and slit in gasket.
4.
Ensure wall mount plate is level. Fully tighten fasteners (use washers as required to ensure a secure fit).
Conduit-stub up (figure d)
5-9. Continue install of the fixture per steps 5 thru 9 as
detailed above.
Conduit-surface (figure e)
5-7. Continue install of the fixture per steps 5 thru 7 as
detailed above.
8.
Attach ½"NPT conduit fittings using the appropriate
EMT rain tight compression connections(not provid-
ed) onto the factory machined conduit entry opening.
9.
Make supply wire (power and dimming) to fixture wire
connections as required thru splice access.
10.
Secure splice access cover in place using provided 10-
24 socket head cap screws (40-50 in-lbs).
Troubleshooting: If this fixture fails to operate properly, check
to make sure: • The fixture is wired correctly.
is grounded correctly.
• The line voltage at the fixture is cor-
rect. If all these variables have been checked and the fixture still
does not operate as specified, contact your local Lithonia Lighting
distributor.
©2016 Acuity Brands Lighting, Inc.
All Rights Reserved.
Conduit Installation Instructions (figures a,b,c)
• The fixture
1/4-20 screws
Splice access cover
10-24 screws
figure c
figure d
Conduit
Conduit
Splice access cover
10-24 screws
figure e
Part Number: RJ521397 Rev A
Revision Date: 5/5/16