Cisco MERAKI MR66 Посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник для Шлюз Cisco MERAKI MR66. Cisco MERAKI MR66 7 сторінок. Troubleshooting mesh communication between access points
Також для Cisco MERAKI MR66: Посібник з монтажу (20 сторінок)

Друкувати сторінку

Connectivity Problems

There are three common Dashboard connectivity warning messages:

• Unreachable

• Unable to find a gateway

• Repeater warning

Unreachable

When a repeater loses connection to the Internet and Dashboard, it will appear as a red icon with a status of "unreachable" on the AP details page.

Unable to Find a Gateway

A repeater can mesh through Meraki APs located outside of its own network/organization if it is unable to find a mesh route to the Internet/Dashboard through

APs within its own Dashboard network. In this state, the AP will appear as a yellow icon with an "Unable to find a gateway to the Internet" status on the AP

details page.

Note: Repeaters that have a mesh route outside the network will not advertise SSIDs configured in Dashboard or forward client traffic.

Repeater Warning

A repeater can get into a bad connectivity state where there is one-way communication between itself and the cloud. In this state, the cloud receives

management traffic from the repeater, but when it replies, it does not receive acknowledgement from the repeater. In this state the repeater will alert "bad

connectivity to the controller, possible firewall or NAT issues":

Checking Historical Status of a Repeater

The historical connectivity status of a repeater can be seen by toggling the Connectivity graph on the AP details page. Place the mouse pointer over the colored

lines on the graph, to view the timeframe of mesh connectivity status changes.

Check for Mesh Neighbors

If two APs operate on the same channel and are within range of each other, they can become mesh neighbors. Mesh neighbors exchange mesh route

information allowing repeaters to discover the best metric route to the gateway. If two APs are in the same Dashboard network and mesh neighbors, they may

establish a mesh routing relationship where they send and receive client traffic of the mesh link.

This information can be immensely helpful in narrowing down bad mesh links and determining next steps.

Check the Mesh Neighbors table

APs that are mesh neighbors will appear in each other's mesh neighbors table (on the AP details page, under Wireless > Monitor > Access points > The

repeater experiencing issues). When a repeater is offline, the first step is to confirm whether it shows up in the mesh neighbors table of other APs it should

route through.

Figure 6: A repeater "Repeater 1" is a mesh neighbor of the "Gateway" AP, as it appears in Roof's mesh neighbors table.