Cisco Physical Access CIAC-GW-K9 Встановлення та налаштування - Сторінка 21
Переглянути онлайн або завантажити pdf Встановлення та налаштування для Шлюз Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 сторінок. Physical access gateway
Також для Cisco Physical Access CIAC-GW-K9: Посібник із швидкого старту (17 сторінок)
Друкувати сторінку
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Procedure
To upgrade the Gateway firmware from a PC directly connected to the module, perform the following
procedure:
Log on to the Gateway administration tool, as described in the
Step 1
on page
Click the Image Management tab, as shown in
Step 2
Figure 2-15
Determine the active and running firmware images:
Step 3
The Image Management window displays all firmware images loaded on the Gateway. The running
image is the firmware currently operating the Gateway module. The active image is the image that will
become the running image when the Gateway module is reset. The table displays the images currently
loaded on the module:
Current Images: a list of the firmware images currently loaded on the Gateway module.
•
Running: the green check in the Running column indicates the image operating the Gateway.
•
Active: the green check in the Active column indicates the image set as the active image. This is the
•
image that will become the Running image when the Gateway is reset.
Upload a new firmware image from a file located on a local disk or on a remote TFTP server:
Step 4
You can also choose an existing image: highlight the image name, click the Set Active button, and then
Tip
reset the Gateway. The new active image becomes the running image only after the Gateway is reset (see
the
"Soft Reset (Powercycle)" section on page
OL-32499-01
2-16.
Image Management for the Cisco Physical Access Gateway
Configuring and Managing the Gateway Using a Direct Connection
"Connecting a PC to the Gateway" section
Figure
2-15.
2-25).
Cisco Physical Access Gateway User Guide
2-21