Acuity Brands JUNO JFX Series Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Контролер Acuity Brands JUNO JFX Series. Acuity Brands JUNO JFX Series 3 сторінки. Rgbw rf controller

Друкувати сторінку

JFX™ SERIES RGBW RF CONTROLLER

WARNING

This RF Controller should only be powered by ACCUDRIVE

ACCUDRIVE™ drivers may damage controller and void warranty. See Drivers & RF Controller Spec sheet for more detailed

information. Failure to follow instructions will void product warranty.

IMPORTANT SAFETY INSTRUCTIONS

• Read all these instructions before starting installation.

• Keep these instructions in a safe place for future reference.

• Only qualified electricians in accordance with local codes should install these fixtures.

• De-energize electrical circuit at circuit breaker prior to installation process. Always ensure power is off

before making any changes to installation.

• Do not connect directly to high voltage power. Must be connected to approved Class 2 LED driver.

• Do not disassemble or modify these products beyond instructions or warranty will be voided.

• Only install in an Indoor dry location.

• Ensure wire gauge used from driver to controller and controller to LED strip is sufficient to maintain a

voltage drop under 3% (See Spec Sheet for details).

SAVE THESE INSTRUCTIONS

Step 1. (RF Controller - System Installation)

Once mounting locations are determined for the LED driver junction box, RF Controller, and LED strips refer to controller wiring guide

(Figure 1).

Step 2. (RF Controller – Sync Remote to Receiver)

Remote requires 3x AAA 1.5V batteries (Not Included).

Press the Power button to turn on remote (Figure 2).

Press LEARNING KEY button on receiver (Figure 1).

Swipe finger on color

wheel. LED strip will flash

to indicate learning. Once

flashing has stopped the

setup is complete.

Reset Receiver / Unpair

If necessary, the remote can be unpaired from the receiver. To

unpair hold the LEARNING KEY down for 5 seconds until LED light

strip flashes twice. This will delete the controller ID. To re-sync

remote follow steps above. In the event the remote become

inoperable cycle power feed to LED strips. If problem persists reset

receiver and re-sync remote.

WARRANTY

5-year limited warranty. Complete warranty terms located at:

www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx

Technical Services Phone (888) 387-2212

INSTALLATION INSTRUCTIONS

One Lithonia Way • Conyers, GA 30012 • (800) 705-SERV (7378) • www.acuitybrands.com

JFX Series Class 2, 24VDC Drivers. Use of non-

Rev. 04/22

P4916

1 of 3