Acuity Brands nLight rIO Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Контролер Acuity Brands nLight rIO. Acuity Brands nLight rIO 3 сторінки. Fixture embedded nlight air network interface

Друкувати сторінку

rIO BASIC OVERVIEW

• The rIO is a wireless controller that can be interconnected with the nLight® AIR network of wireless sensors and switches.

• The rIO is only compatible for use in fixtures with eldoLED L-series, S-series drivers, or other analog (0-10VDC) third party aux drivers.

• The rIO with EM option provides UL924 emergency operation when paired with an EldoLED driver that supports power loss detection. Emergency

transfer switches must be break-before-make, delayed transition type, and set to ensure at least 200 msec interruption of load power when

transferring from normal to emergency sources. All testing must be performed in a manner which ensures this interruption of the power

supplied to the egress lighting.

TYPICAL INSTALLATION INSTRUCTIONS (may vary by luminaire)

• Attach foam pads to surface of rIO as shown. Adjust thickness of pad as needed to fill gap between controllerbody and end cap.

• Attach wires to controller according to the diagram below. Wire locations are also shown on product label.

• Ensure thin wire antenna points toward the center of the fixture, between the LEDs and diffuser.

• Place the rIO in the fixture, with the rIO cylinder aligned to the clearance hole.

• Insert rIO lens assembly through the hole, securing it to the sensor body.

• Install diffuser.

• The sensor is intended for installation in lighting fixtures only with no accessible un-insulated live parts after installation.

CONTROLLER BODY

FOAM PADS

COVER ASSEMBLY

TYPICAL INSTALLATION FOR EXTERNAL ANTENNA (optional)

• Attach wires to sensor according to the

wiring diagram below. Wire locations

are also shown on product label.

• Route the coax cable through the inside

of the fixture to the antenna hole.

• Affix the o-ring, washers, and nut as

indicated on the drawing (2) to the

external surface of the fixture.

• Attach external antenna (1) to the brass

SMA connector. Torque spec for proper

installation is 5in-lbs.

• Place the rIO in the fixture, with the rIO

cylinder aligned to the clearance hole.

• Secure the lens assembly to the rIO

body.

NOTE

1. rIO with external dual-band antenna can be installed internal to the fixture (cap not required). In this configuration, the an-

tenna needs to be installed external of the fixture.

2. When used in an outdoor environment, proper sealing of the antenna is required.

For further troubleshooting guidance, please contact the Controls Technical Support Team

IS-RIO-002

rIO Controller

Fixture Embedded nLight AIR Network Interface

LOW VOLTAGE

WIRELESS

•

NUT

LOCK WASHER

O-RING

SECTION VIEW OF EXPLODED DUALBAND ANTENNA IN

CASTING DETAIL

1(800)-535-2465

HOLE

ANTENNA

FLAT WASHER

0.85

PROVIDE CLEARANCE FOR

ASSEMBLY TOOL

0.150

0.056

0.390

0.044

0.250

MOUNTING HOLE DETAIL

2 of 3