Cisco VG400 series Посібник з встановлення обладнання - Сторінка 25
Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Шлюз Cisco VG400 series. Cisco VG400 series 40 сторінок. Voice gateway
Також для Cisco VG400 series: Посібник з налаштування програмного забезпечення (22 сторінок), Встановлення (13 сторінок)
Друкувати сторінку
- 1. Table of Contents
- 2. Location and Mounting Requirements
- 3. Temperature Control and Ventilation
- 4. Rack Requirements
- 5. Access to Chassis
- 6. Power Source and Supply
- 7. Network Cabling Considerations
- 8. Interference Considerations
- 9. Required Tools and Equipment for Installation
- 10. Site Log
- 11. Installation Checklist
Installing the Cisco VG400 Voice Gateway
3
3. Use the screws provided with the rack to install the chassis in the rack. For both the 19-inch EIA brackets
and the 23-inch SBC brackets, start the lower pair of screws first, and rest the brackets on the lower screws
while you insert the upper pair of screws.
Tip
The screw slots in the brackets are spaced to line up with every second pair of screw holes in the rack. When
the correct screw holes are used, the small, threaded holes in the brackets line up with unused screw holes in
the rack. If the small holes do not line up with the rack holes, you must raise or lower the brackets to the next
rack hole.
The following image shows a typical installation with back mounting
Figure 5: Bracket Installation for Back Mounting
1
19-inch EIA brackets
4
Mounting Screws (4)
Cisco VG400 Voice Gateway Hardware Installation Guide
Mount Cisco VG400 Voice Gateway Chassis in Rack
19-inch EIA brackets
23