DIGIWAY PTY SW50-2S Інструкція з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Відкривач воріт DIGIWAY PTY SW50-2S. DIGIWAY PTY SW50-2S 17 сторінок. Dual swing gate motor
Друкувати сторінку4.3 Sample of five wires with N/C limit
4.4 Step by step set up motor.
a) Mounting and connect motor
b) Disengage cutch and push two gates in middle position, then engage clutch. Power up,
push OPN button, gate should open, if any gate goes close direction, switch motor two
wires.
c) Adjust limit switch (make sure DIP4 limit switch selection is matched to limit switch).
(1) If 5 wires system, turn power off and disengage clutch and setting limits switch.
Move gate to closed potion and adjust closed limit stop to touch the limit switch
and this limit should connect to closed limit switch in put on control board. Open
gate to opened position do the same things for opened limit switch.
(2) If 2 wires system with limit switch with diode, need keep power on, push remote,
while gate is running (either open or close), using screw driver touch limit switch,
so can find out which limit is for open or close. Turn power off, then disengage
clutch, push gate and set up limit switch.
(3) If two wires system without limit switch, in this case, opened and closed
mechanical stopper must be installed. Adjust motor force pot to suit actual gate
power requirement.
d) Power up, use remote or push button to operate gate. Controller will automatically learn
soft stop positions. After two fully close and open cycles, auto-learn procedure finish.
- 15 -