Epson DLQ-3500 Короткий посібник - Сторінка 29
Переглянути онлайн або завантажити pdf Короткий посібник для Аксесуари для принтерів Epson DLQ-3500. Epson DLQ-3500 32 сторінки. Epson serial impact dot matrix printers
Також для Epson DLQ-3500: Посібник з налаштування (31 сторінок), Повідомлення (1 сторінок), Довідковий посібник (34 сторінок)
Друкувати сторінкуAdjusting the top-of-form position
The top-of-form position is the position on
the page where the printer starts printing. If
your printing appears too high or low on the
page, you can use the Micro Adjust function
to adjust the top-of-form position.
Follow these steps to adjust the top-of-form
position:
c
Caution:
Never use the knob to adjust the
top-of-form position; this may damage the
printer or cause it to lose the top-of-form
position.
Note:
❏ Your top-of-form position setting remains in
effect until you change it, even if you turn off
the printer.
❏ The top margin setting made in some
application software overrides the
top-of-form position setting you make with
the Micro Adjust function. If necessary,
adjust the top-of-form position in your
software.
1. Make sure the printer is turned on.
2. Press the Pause button to stop printing.
The Pause light comes on.
3. Load paper. Press the Load/Eject
button to advance continuous paper to
the current top-of-form position. If
necessary, lift up the printer cover so you
can see the paper position.
4. Hold down the Pause button for about
three seconds. The Pause light starts
flashing and the printer enters the Micro
Adjust mode.
EPSON DLQ-3500 Quick Guide
5. Press the LF/FF D button to move the
top-of-form position down on the page,
or press the Load/Eject U button to
move the top-of-form position up on the
page.
Note:
❏ The printer has a minimum and a
maximum top-of-form position. If you
try to adjust it beyond these limits, the
printer beeps and stops moving the
paper.
❏ When the paper reaches the default
top-of-form position, the printer also
beeps and stops moving the paper
briefly. You can use the default setting
as a reference point when adjusting the
top-of-form position.
6. After you set the top-of-form position,
press the Pause button to exit the Micro
Adjust mode.
Micro Adjust Function (4/4)