Acuity Brands Lighting Holophane Wallpack HLWCP2 Посібник з монтажу та обслуговування - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу та обслуговування для Зовнішнє освітлення Acuity Brands Lighting Holophane Wallpack HLWCP2. Acuity Brands Lighting Holophane Wallpack HLWCP2 6 сторінок. Full cutoff led luminaire

Друкувати сторінку
HOLOPHANE
Index
DESCRIPTION
Introduction
Installation
Tools and Materials Required
Wiring the Luminaire – Std. Luminaire
Wiring the Luminaire – Emergency
Battery Pack (EM Option)
Wiring the Luminaire – Two
Independent Circuit (2CI Option)
Attaching Heatsink to Electrical
Housing
Optional 0-10V DC Dimming Controls
Maintenance
Limited Warranty and Limitation of
Liability
Field Adjustable Output (AO) Tables
Figure 1
1 Introduction
1.1 Product Description. The Wallpack® Full Cutoff
LED luminaires have been designed and tested in
accordance with applicable UL/CSA standards and are
suitable for use in wet locations. Installation is limited to
wall mount only. This luminaire is not suitable for up-light
applications. Luminaire max weight is 24 lbs.
 
®
Wallpack
LED Luminaire (HLWCP2)
SECTION
1
2
2.2
2.3
2.4
2.5
2.6
2.7
3
4
5
GR2673
®
Full Cutoff
2 Installation
2.1 Tools and Materials Required.
TABLE 1. Installation Tools and Materials
DESCRIPTION
Slot-head screwdriver
(required)
Phillips-head screwdriver
(recommended)
Drill and bit sized per fastener
Mounting fastener (variable;
must be appropriate size and
thread for mounting substrate)
Silicon Sealant or equivalent
2.2 Mounting Luminaire to Wall
2.2.1 Loosen the 6 screws that hold the front heatsink to
the electrical housing (figure 2)
2.2.2 Fully separate the front heatsink from the electrical
housing by pulling the heatsink directly away from the
electrical housing. Disconnect hooks and wires or wire
harnesses and set the heatsink aside where it will not be
damaged. When disconnecting any wiring, do not
remove any wire labels.
Figure 2
2.2.3 Drill out necessary anchoring holes at indicated
drill points. Drill points are within the dashed box shown
on figure 3.
 
Installation and
Maintenance
Manual
USE
Electrical housing
access
Drilling mounting holes
into electrical housing
Mounting luminaire
Sealing luminaire
against water intrusion
after installation
  IM‐438‐B 
GR2674