DIHL WF-32BDSS Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Охолоджувач для вина DIHL WF-32BDSS. DIHL WF-32BDSS 9 сторінок. Wine refrigerator
Друкувати сторінкуClean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
Install the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold or hot ambient temperatures may also cause the appliances not to perform properly.
The unit is not designed for placement in garage or basement. It is designed for use inside the
home.
Electrical Connection
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized products service center.
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
3-pin plug which mates with 3-pin wall outlets to minimize the possibility of electrical shock. Do not
under any circumstances cut or remove the ground wine from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 220V-50HZ electrical outlet with 3-pin plug.
The cord should be secured behind the wine refrigerator and not let exposed or dangling to prevent
accidental injury.
Operating Your Wine Refrigerator
It is recommended that you installed the wine refrigerator in a place where the ambient temperature is
between 10-26℃.If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected. For example, placing in extreme cold or hot conditions may
cause interior temperature to fluctuate. The range of 8-18℃ may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the
bottles are located on the upper, middle or lower section.
How to use the press-buttons on the Display Panel:
You can set the temperature as your desire by pressing the button. There are three press-button on the
panel " " and " " to adjust the temperature by 1℃ among 8-18℃.
You can turn the interior light on or off by pressing the "Light" button.
Warning