Acuity Brands Lighting Juno MonoLine L Wall Feed MLP165 Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Освітлювальне обладнання Acuity Brands Lighting Juno MonoLine L Wall Feed MLP165. Acuity Brands Lighting Juno MonoLine L Wall Feed MLP165 3 сторінки.
Друкувати сторінкуSAVE THESE INSTRUCTIONS and refer to them when making any additions or
changes to the track configuration.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions prior to installing this product.
2. Disconnect electrical power before adding to or changing the configuration of the track.
3. Do not install this track in damp or wet locations.
4. Do not install any part of track system less than 5 feet above floor.
5. Do not attempt to energize anything other than lighting fixtures and fittings intended for use on MonoLine track.
WARNING
BE SURE TO TURN OFF POWER TO THE JUNCTION BOX BEFORE INSTALLATION.
Track Rail
MLP166
Cut cable to
desired length
Track Rail
MLP165
WARRANTY
Juno Lighting Group warrants that its products are free from defects in material and workmanship for one year from date of purchase,
two years from date of purchase for Energy Star
replacement, without charge, at Juno Lighting Group's factory after prior written return authorization has been granted. This warranty
shall not apply to products which have been altered or repaired outside of Juno Lighting Group's factory. This warranty is in lieu of all
other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes any implied warranty of
merchantability. Also, there are no warranties which extend beyond the description of the product on the company's literature setting
forth terms of sale.
Product Services Phone (888) 387-2212
1300 South Wolf Road • Des Plaines, IL 60018 • www.junolightinggroup.com
INSTALLATION INSTRUCTIONS
Cut cable to
desired length
Loosen Cable Coupling
set screw to adjust cable
to desired length
Cut excess cable
close to connector
Loosen Cable Coupling
set screw to adjust cable
to desired length
Cut excess cable
close to connector
rated fixtures. Juno Lighting Group's obligation is expressly limited to repair or
®
MLP165 MonoLine
MLP166 MonoLine
MLP165 MonoLine "L" Wall Feed
MLP166 MonoLine "T" Wall Feed
1
Mark position of each cable support.
2
Unscrew mounting flange from top finial.
Drill hole in wall at desired anchor
3
location.
Insert enclosed anchor plug into drilled
4
hole.
5
Position mounting flange over anchor
plug, insert enclosed screw and secure
flange to wall.
6
Screw top finial with cable onto flange.
Loosen set screw in cable coupling.
7
Raise or lower joiner assembly to desired
8
position along cable.
9
Retighten cable coupling set screw.
Cut off cable as close as possible to
10
cable coupling.
11
Return to Step 7 on page 1.
©2016 Acuity Brands Lighting, Inc.
"L" Wall Feed
®
"T" Wall Feed
®
Printed in China
Rev 7/11
P3201
CABLE
SUPPORT
Loosen Lower
Finial set screw
to raise or lower
joiner
Cut excess
cable close
to Lower Finial
pg 2 of 2