Acuity Brands Lighting Lithonia Lighting HLF LED Інструкція з монтажу Посібник з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Освітлювальне обладнання Acuity Brands Lighting Lithonia Lighting HLF LED. Acuity Brands Lighting Lithonia Lighting HLF LED 7 сторінок.

Друкувати сторінку

SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION

To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/

abrasions, and other hazards please read all warnings and instructions included with and on the fixture box and

all fixture labels.

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general

precautions.

Installation and service of luminaires should be performed by a qualified licensed electrician.

Maintenance of the luminaires should be performed by person(s) familiar with the luminaires' construction and

operation and any hazards involved. Regular fixture maintenance programs are recommended.

It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on

ambient dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a

solution of warm water and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry.

Should optical assembly become dirty on the inside, wipe refractor/lens and clean in above manner, replacing

damaged gaskets as necessary.

DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have

been damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should

be replaced.

Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.

These instructions do not purport to cover all details or variations in equipment nor to provide every possible

contingency to meet in connection with installation, operation, or maintenance. Should further information

be desired or should particular problems arise which are not covered sufficiently for the purchaser's or owner's

purposes, this matter should be referred to Acuity Brands Lighting, Inc.

RISK OF ELECTRIC SHOCK

 Disconnect or turn off power before installation or

servicing.

 Verify that supply voltage is correct by comparing it with

the luminaire label information.

 Make all electrical and grounded connections in

accordance with the National Electrical Code (NEC) and

any applicable local code requirements.

 All wiring connections should be capped with UL

approved recognized wire connectors.

 Wear gloves and safety glasses at all times when

removing luminaire from carton, installing, servicing or

performing maintenance.

 Avoid direct eye exposure to the light source while it is on.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS!

WARNING

CAUTION

RISK OF INJURY

WARNING

RISK OF BURN

 Allow lamp/fixture to cool before handling. Do not

touch enclosure or light source.

 Do not exceed maximum wattage marked on

luminaire label.

 Follow all manufacturer's warnings, recommendations

and restrictions for: driver type, burning position,

mounting locations/methods, replacement and

recycling.

CAUTION

RISK OF FIRE

 Keep combustible and other materials that can burn,

away from lamp/lens.

 Do not operate in close proximity to persons,

combustible materials or substances affected by heat

or drying.