Crow EDS-2000AM Інструкція з монтажу та посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Датчики безпеки Crow EDS-2000AM. Crow EDS-2000AM 20 сторінок. Outdoor pir + mw detector
Також для Crow EDS-2000AM: Інструкція з монтажу Посібник з монтажу (18 сторінок), Інструкція з монтажу Посібник з монтажу (18 сторінок)

Selecting mounting location

The installation of the EDS-2000 requires straight and solid base for the detector and setting of

front panel against the center of protected area.

The protected area must be free from obstacles like walls, fences, trees, ditches and other

microwave detectors, as well as systems of anti-intrusion surveillance.

The bracket provides EDS-2000 installation on a wall. The wall should be leveled.

Choose a location most likely to intercept an intruder according to detection pattern on page 8.

Avoid the following Installation Locations:

 Facing direct sunlight.

 Facing areas subject to rapid temperature changes.

 Wall angle of more than 10º from perpendicular line.

 Mounting at more than 10º Deviation from horizontal line.

 Facing metal doors.

 Do not install near direct source of heat or air gust.

 Clear all physical obstacles from the detection area

(e.g. Plants, laundries, etc.)

 Clear all light reflecting surfaces from the detection area,

as well as water puddles.

 Avoid installation on the following types of ground:

Thick vegetation, Grass (un-mown), Water, Sand and Metal.

NOTE:

Recommended installation height is 2.1m (6.9ft).

The PIR sensor detects motion crossing the beam; it is less sensitive detecting motion towards

the detector.

The EDS-2000 performs best when provided with a constant and stable environment.

In order to ensure suitable operation of the EDS-2000 type of ground should be one of the

following: Asphalt concrete, Cement, Soil, Clay, Gravel or Grass (mown).