Argos 84840 Посібник з монтажу та експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для гриль Argos 84840. Argos 84840 14 сторінок. 3 burner flat gas bbq with timber trolley
Друкувати сторінку
the expiry date.
3. Connecting the Gas Hose to the Barbecue
Connect the gas hose to the gas rail inlet on the left hand side of the barbecue. Do not
over tighten. Do not use any sealing tape or liquid on the connection.
4. Fixing the Regulator to the Gas Bottle
Confirm all barbecue control knobs are in the off position. Connect the regulator to the
gas bottle according to your regulator and bottle dealer's instructions.
5. Leak Testing (To be performed in a well-ventilated area.)
Confirm all control knobs are in the off position. Open the gas control valve on the
bottle or regulator. Check for leaks by brushing a solution of 1/2 water and 1/2 soap
over all gas system joints, including all valve connections, hose connections and
regulator connections. NEVER USE AN OPEN FLAME to test for leaks at anytime. If
bubbles form over any of the joints, there is a leak. Turn off the gas supply and
retighten all joints. Repeat test. If bubbles form again, do not use the barbecue.
Please contact your local dealer for assistance. Leak test annually, and whenever
the gas bottle is removed or replaced.
D. Operation
1. Warnings
Before proceeding, make certain that you understand the IMPORTANT
INFORMATION section of this manual.
This barbecue is not designed to be used with more than 70% of the cooking area as
a solid plate. Full coverage of plates will cause excessive build-up of heat and
damage the barbecue.
Open the lid when you want to control the flame.
2. Preparation Before Cooking
To prevent foods from sticking to the cooking grill, please use a long handled brush to
apply a light coat of cooking or vegetable oil before each barbecuing session. (Note:
When cooking for the first time, paint colors may change slightly as a result. This is
normal and should be expected.)
3. Lighting The Burner
Lighting Instructions:
1.
Open lid before lighting.
2.
Set all control knobs to "OFF" and turn on the gas supply.
3.
Push and turn second left control knob to "HIGH".