Epson S020047 Інструкція по поповненню

Переглянути онлайн або завантажити pdf Інструкція по поповненню для Аксесуари для принтерів Epson S020047. Epson S020047 1 сторінка. Epson printer accessories user manual
Також для Epson S020047: Інформаційний листок продукту (4 сторінок)

Друкувати сторінку

EP4749CB

REFILL INSTRUCTIONS

For Epson® S020047,

S020049

Using the hand held drill bit, drill a hole at the vent holes shown above. Drill until you feel the drill bit go

all the way through. Wash the bit with water between each new hole drilled. Attach the needle to the

syringe and draw the proper color and amount of ink into it. Place the cartridge to be filled on a paper

towel in case of spillage. Using the yellow seals cover the exit holes on each color to avoid leakage.

Insert the needle into the hole you predrilled and slowly inject the ink and at the same time lift up slightly to

expose the ink to different parts of the internal sponge inside the cartridge. The cartridge may or may not

take all of the ink, depending on how empty each color was. Wash the injector between colors to prevent

contamination. If the cartridge is to be used soon after refilling do not cover the vent holes with tape as

these are vents and need to be open in order for the cartridge to work.

Care should be used in filling these cartridges since the print head is internal and made to be permanent,

which makes it susceptible to small particles clogging it over time. Both have an internal sponge for ink

retention. The exit holes need to be resealed to prevent leaking. Use the yellow round sealing dots to cover

the ink exit holes to avoid leaking when refilling. Remove the seals before installing the cartridge back into

your printer. For long term storage, cover the top openings with tape to prevent the cartridge from drying

out.

PRINTS IN STREAKS / MISSING LINES : Perform print head clean procedure as described in the

owners manual.

CARTRIDGE LEAKS: Cartridge is not sealed properly. Reseal cartridge. The cartridge is overfilled.

Place on a paper towel until it stops leaking.

MODEL STYLUS COLOR 200/II/IIS/

MODEL STYLUS COLOR 1500 (COLOR ONLY)

STEP 1

STEP 2

IMPORTANT

TROUBLE SHOOTING

ATLASCOPY.COM

P.O. Box 1292

Dover, DE. 19904

Contents:

Your kit should contain the following:

4 - 2oz bottle of ink, 1 10cc ink injector, 2 polly

wipes, 8 yellow seals, needle, drill tool,

instructions.

If any of these items are missing please call us for a

replacement item or kit.