Crow EDS-2000AM Інструкція з монтажу Посібник з монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Аксесуари Crow EDS-2000AM. Crow EDS-2000AM 18 сторінок. Outdoor pir + mw detector
Також для Crow EDS-2000AM: Інструкція з монтажу Посібник з монтажу (18 сторінок), Інструкція з монтажу та посібник користувача (20 сторінок)

9. Anti mask

The EDS-2000-AM has a sophisticated anti mask module:

This module is assembled on the EDS-2000-AM main board.

To activate the AM please pull up SW2 position 2 and remove the PET optic filter.

The EDS-2000-AM has an ambient light sensor.

The EDS-2000-AM self calibrates for anti mask 30 minutes after power up.

Please verify during installation that the EDS-2000-AM is closed well before 30 minutes

from power up.

In case initial calibration is done while facing direct sunlight, the calibration process will be

automatically reinitiated after 30 mins until the direct light intensity is reduced adequately.

Mask indication is obtained once the detector mask functionality is activated. This is

achieved once the detector is optically blocked (pained, covered)

In order to restore mask condition, remove the obstacle from the detector and generate

basic detection to generate intrusion alarm – this may be acheieved by walking or waiving

in front of the detector.

10. Operation

Note! Connect the EDS-2000-AM to a positive Voltage output of 9 -16VDC source.

Use only a listed power limited source.

The detector shall be provided with minimum of 4 hours of standby power from either a

listed compatible control unit or power supply.

The detector is automatically operated once connected to power.

The LEDs start flashing one at a time (side to side) for 30 seconds during the warm-up

period and after that they will turn off.