Argos Challenge FS40-9HRA Інструкція з монтажу Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вентилятор Argos Challenge FS40-9HRA. Argos Challenge FS40-9HRA 8 сторінок. 5 blade ped fan with remote
Друкувати сторінку
ASSEMBLY OF BASE & COLUMN
UNIT
1. Unscrew the L shape screw from
the Extension Pole. (Fig.1)
2. Insert the extension pole in the
chassis and tighten the L shape
screw. (Fig.2)
3. From the extension pole loosen the
height adjustment ring and adjust
the internal pipe to the desired
height. (Note: If you can't find the
internal pole, it slides inside the
extension pole.You can pull it out
from the extension pole.) (Fig.3)
4. To attach the head unit to the
extension pole, loosen the thumb
screw on the bottom of the head
unit. Place the head unit on the
extension pole and tighten the
thumb screw in alignment with the
groove on the internal pole. (Fig.4)
CAUTION: Height adjustment ring
must be fully fastened before the
assembly of the motor section
to the extension pole.
GUARD & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or
take the spinner out from the bag)
and the plastic nut counter
clockwise to remove both of them.
Fix the rear guard to the motor then
tighten the plastic nut again (Figure
5).
2. Insert the blade into shaft, and
make sure the rotor shaft pin is
fitted into groove of the blade.Turn
the spinner counter clockwise to
tighten the blade (Figure 6)
3. Fix the front guard and the rear
guard with circlip and then screw
the locking screw to tighten the fan
guard. (Figure7&8).
5
Fig.5
Fig.6
locking screw
Fig.7
Fig.8
OPERATING INSTRUCTIONS
The unit comes with a remote control
for use with the fan.The fan unit will
emit a beep whenever it receives a
signal from the remote control.
I. Remote Control
KEY
This key is for switching on the fan.
The fan will be started at medium.
After 2 seconds it will automatically
over to the low step. Press this key
again if the fan needs to switch off.
KEY
Press the TIMER key. The TIMER
light is flashing the timer dial and the
first finger light are on. Each finger
light represent half an hour in the time
dial.
The fan is delivering air/stop when the
finger light is on/off.
This key is touched repeatedly for
selecting the timer.
The timer will be increased by half an
hour timely and sum to the 7.5 hours
finally.
The press of time slot must be in 5
seconds, otherwise the timer setting
is finished automatic. The TIMER
LED stop flashing after finishing the
setting. When all finger lights are off,
the fan will stop.
Timer for ON, Must press the timer
when the fan is off.
Timer for OFF, Must press the timer
after the fan is on.
KEY
The unit is equipped with 3 speed
"low-medium-high"settings. To
change the fan speed,press the fan
speed key until the desired fan speed
is selected.
6