Acuity Brands Lighting HYDREL Інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Прожектор Acuity Brands Lighting HYDREL. Acuity Brands Lighting HYDREL 4 сторінки.
Друкувати сторінкуiNSTALLATiON iNSTRUCTiONS
WARNiNG:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, INJURY OR SIGNIFICANT PROPERTY DAMAGE
For your protection, read and follow these warnings and instructions carefully before installing this fixture. These instructions do not attempt to cover all installation
situations. If you do not understand these instructions or additional information is required, contact Hydrel Lighting or your local Hydrel Lighting distributor.
Fixture to SSBR Surface Box Connection
1)
Route fixture cord along fixture and Mounting Plate Rod (H) and secure with provided Wire Keepers (I) (J).
Trim excess cord at SSBR, strip back jacket approximately 4", and slide through ½" Cord Seal (K) provided.
2)
a. Note: ½" Cord Seal (K) may be utilized on either side of SSBR as required by installation.
3)
Make electrical load connections as indicated on the labeled conductors and per all NEC and local code
requirements.
H
Mounting Plate Rod
I
Wire Keepers
J
Wire Keepers
K
Cord Seal
RHYTHM SERiES
SSBR
9144 Deering Avenue | Chatsworth, CA 91311 | www.hydrel.com
Phone: 866.533.9901 | Fax: 866.533.5291
Installation should be performed by a qualified
electrician in accordance with the National Electrical Code
and relevant local codes.
I
K
J
H
©2014 Acuity Brands Lighting, Inc.
7/29/14
INS-RHYTHM