Dillon ED-2000plus Посібник користувача - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Dillon ED-2000plus. Dillon ED-2000plus 20 сторінок. Electronic dynamometer with hr-2000 remote
Appendix - Weighing and Force Measurement Practice
Load Centering
Good Pin Fit
Torque and Bending
Certified Gear
Safety
18
The basis for all electronic force measurement or weighing is measurement of
stress in a loadcell body. To obtain optimal results it is necessary to estab-
lish a few basic rules, otherwise the effect may be a nonlinear or
nonrepeatable response. Read and follow these tips and see the illustrations
on the next page.
For accurate performance the force
acting on the unit must be in line with
the unit. Centering the load is accom-
plished by using the shims on each side
of the load cell so that it is centered on
the shackle pin. See the illustration at
right. The 20, 50, and 100 Klb
ED-2000plus also include spacers
supplied with shackles.
A good fitting pin is important in order to
generate an even stress distribution and
avoid yield stresses. The ED-2000plus
are designed with the recommended
shackle pin hole sizes for the Crosby
shackle capacity. To achieve published
accuracy you must use the shackle
pins and centering spacers provided by
Dillon.
Torque and bending should be avoided.
Use swivels on the lifting wire for
antitorque and avoid side forces.
Certified shackles and lifting gear
should always be used in accordance to
local laws and federal legislation.
Safety is always a concern in overhead lifting and tensioning applications. To
limit your liability always insist upon factory supplied shackles and pins and
factory tested and certified safe optional equipment. All DILLON products are
designed to meet the published Safe Working Load (SWL) and Ultimate
Safety Factor (USF) standards of the United States Military.