Dillon ED-2000plus Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Dillon ED-2000plus. Dillon ED-2000plus 20 сторінок. Electronic dynamometer with hr-2000 remote

Друкувати сторінку

RS-232 Operation

The force value received is right

justified with any leading zeroes

replaced by spaces. Negative

values will show a minus sign

before the first digit. The

decimal point will not be printed

if it follows the significant

digits.

You can operate the ED-2000plus with a computer or other data logging

device via RS-232. To place the ED-2000plus in RS-232 mode, use one hand

to press and hold the F key and use the other hand to press the ON key.

This operation is transparent to the user. It is important that the ED-2000plus

and the external device are set at a baud rate of 2400 for RS-232 communica-

tion.

When you press the DATA SEND key in RS-232 mode, or send an enquire

code from the external device to the ED-2000plus, the following information is

sent to the external device:

xxxxx.x uu CR/LF

x = force value

u = unit of measure (LB, KG, KN or T)

CR/LF = carriage return and line feed

The enquire code is a single question mark (?). When the ED-2000plus

receives this code from the external device, the above information is sent.

If your RS-232 port is receiving garbled data, check to be sure you are in

RS-232 mode or that an HR-2000 is not trying to communicate with the

ED-2000plus by radio.