Motorola APX 5000 Посібник користувача - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник користувача для Двостороннє радіо Motorola APX 5000. Motorola APX 5000 45 сторінок. Digital portable radios
Також для Motorola APX 5000: Коротка довідкова картка (2 сторінок), Коротка довідкова картка (2 сторінок), Коротка довідкова картка (2 сторінок), Коротка довідкова картка (2 сторінок)
Друкувати сторінку
•
Do insert S-hooks (not provided) on cables into restraining holes for strain
relief.
•
Do use heat-shrink tubing (not provided) on all splices.
•
Do ensure that unit cables are not placed under stress, are not exposed
to weather, and are not subjected to damage due to engine heat.
•
Do retain in-line cable fuses when trimming cables to fit. Locate in-line
fuses as close as practical to the supply voltage connection.
•
Do not attach the unit to any part of the vehicle that is not rigid or is
subject to excessive vibration.
•
Do not install unit in areas where rain or snow can easily get into them,
such as next to a vehicle window which may be left open.
•
Do not dress cables over sharp edges that could cause wear or tearing of
cable insulation.
•
Do not install the units in locations where they might interfere with the
vehicle's operator or operating controls.
•
Do not install the unit where it will be difficult for the operator to reach.
•
Do not install the unit where it will interfere with vehicle safety air bag
deployment.
Before drilling, check the opposite sides of all mounting surfaces
for obstruction, such as vehicle wiring and fluid lines.
Console Location
The optional trunnion ("U") bracket can be used to mount the APX VA console
either off the vehicle floor or under the vehicle dash. The console should first
be attached to the bracket, and then the console-bracket combination can be
evaluated for the proper mounting location. The console should be mounted to
provide:
•
12 inches (30.48cm) of clearance in front of the console for inserting and
removing the radio.
•
clearance on either side of the console is necessary for inserting and
tightening screws to secure the console to the bracket.
•
a 6-inch (15.24cm) clearance in back of the console for connection of
power, microphone, antenna, and speaker cables.
•
a 1-inch (2.54cm) clearance above the vents on the top of the console.
Consider accessibility to the controls by the operator. Other considerations in
deciding on the best mounting location are:
13