Motorola CLP1040 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Двостороннє радіо Motorola CLP1040. Motorola CLP1040 48 сторінок.

68012000044-ED

Batteries, Chargers, and Audio Accessories Safety Information

Batteries, Chargers, and Audio

Accessories Safety Information

This document contains important safety and operating instructions. Read these instructions carefully

and save them for future reference. Before using the battery charger, read all the instructions and

cautionary markings on:

•

the charger

•

the battery

•

the radio attached with battery

1 To reduce risk of injury, charge only the rechargeable Motorola Solutions-authorized batteries.

Charging the other batteries may cause explosion, personal injury, and damage.

2 Use of accessories not recommended by Motorola Solutions may result in fire, electric shock, or

injury.

3 To reduce damage to the electric plug and cord, pull by plug rather than the cord when

disconnecting the charger.

4 An extension cord should not be used unless necessary. Use of an improper extension cord may

result in fire and electric shock. If an extension cord must be used, make sure that the cord size is

18 AWG for lengths up to 2.0 m (6.5 feet), and 16 AWG for lengths up to 3.0 m (9.8 feet).

5 Do not operate the charger if it has been broken or damaged in any way. Take it to any qualified

Motorola Solutions service representatives.

6 Do not disassemble the charger; it is not repairable and replacement parts are not available.

Disassembly of the charger may result in risk of electrical shock or fire.

7 To reduce risk of electric shock, unplug the charger from the AC outlet before attempting any

maintenance or cleaning.

•

Turn off the radio while charging.

•

The charger is not suitable for outdoor. Use only in dry locations or conditions.

•

Disconnect charger from line voltage by removing main plug.

•

Connect the equipment to an outlet which is easy to access and near.

•

For equipment using fuses, replacements must comply with the type and rating specified in the

equipment instructions.

•

Maximum ambient temperature around the power supply equipment must not exceed 40 °C (104

°F).

•

Make sure the cord is not stepped on, tripped over, subjected to water, damage, or stress.