Epson EL 486UC+ Бюлетень підтримки продукту

Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Робочий стіл Epson EL 486UC+. Epson EL 486UC+ 11 сторінок. Product information guide
Також для Epson EL 486UC+: Інформаційний посібник про продукт (9 сторінок), Технічні характеристики (10 сторінок)

EPSON AMERICA, INC.

Product Support Bulletin

Subject: EL 4S/33+ and EL 486UC+ OS/2 2.0 and 2.1 Display Drivers

Date: 04/06/94

Page(s): 1 of 2

This bulletin announces the availability of enhanced display drivers for the Epson EL

4S/33+ and EL 486UC+ computers running IBM's OS/2 2.0 or 2.1. The 32-bit

Service Pack for version 2.0 from IBM must be installed before installing the new

display drivers. Also, the current system configuration must be VGA or SVGA.

These drivers can be downloaded from the Epson Bulletin Board System (BBS) that

can be reached at (310) 782-4531. They are located in one self-extracting file

(OS2_20.EXE for Version 2.0) or (OS2_21.EXE for Version 2.1) in file library

DRIVERS. Once downloaded, extract the files to a high-density diskette (1.44MB)

by entering the command:

OS2_20 A: or OS2_20 B:

OS2_21 A: or OS2_21 B:

depending on which disk drive is being used. The diskette must have the volume

label OS2 DRVS.

To install a driver, place the Display Drivers diskette into drive A:. Open an OS/2

session, either full-screen or window, and enter the following command:

A:INSTALL A: C:

INSTALL.CMD on the driver diskette copies files to the hard drive and starts the

OS/2 Display Driver Install utility DSPINSTL, which prompts the user.

When the Display Driver Install main panel appears, the Primary Display should

indicate Video Graphics Array. If so, click OK and proceed. If VGA is not selected,

select Primary Display and click OK.

Highlight the Driver/Resolution desired and click OK.

When the Source Directory panel appears, choose the floppy drive ( A: ) which

contains the Driver diskette and click on Install.

When the main panel appears again, click on Cancel.

The new driver has been installed. You must shutdown and then re-boot your

system for the changes to take effect.

EPSON

PSB No: S-0173

Originator: JAM