Epson Endeavor 486C Бюлетень підтримки продукту - Сторінка 3
Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Робочий стіл Epson Endeavor 486C. Epson Endeavor 486C 21 сторінка. Product information guide
Також для Epson Endeavor 486C: Інформаційний посібник про продукт (9 сторінок)
Друкувати сторінку
8. General Installation Tips:
Hardware:
The Discovery CD 16 uses a Sound Blaster 16 sound card. The product was
used in its default configuration. The following are the factory defaults:
Feature:
Base I/O address
Midi address
Board Interrupt
8-bit DMA channel
16-bit DMA channel
Joystick port
Audio Output Amp
These settings can be found in the 'GETTING STARTED' manual that comes
with the product. The system uses a Matsushita model CR-563-B CD-ROM
drive. From the factory the drive ID is set to 0. This jumper is on the rear of the
drive between the power connector and the data/ribbon cable.
Jumper position:
IOS0 closed
IOS1 closed
IS0 open
IS1 closed
DAS0 open
DAS1 closed
DBS0 closed
DBS1 closed
JYEN closed
OPSL pins 2 & 3 closed
OPSR pins 2 & 3 closed
PSB No: S-0171
Page: 3 of 5
Setting used:
220( H)ex
330( H)ex
IRQ5
Channel 1
Channel 5
Enabled
Audio amplified internally:
no external amp needed