Motorola MD207 Series Посібник - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник для Двостороннє радіо Motorola MD207 Series. Motorola MD207 Series 16 сторінок.
Також для Motorola MD207 Series: Посібник користувача (2 сторінок)
Друкувати сторінку
3. Remove the NiMH battery pack from the clear plastic bag (do not disassemble or
unwrap the battery pack).
4. Insert the NiMH battery pack with the diagram facing you.
5. Reposition the battery cover and press down to secure.
Installing the Three AA Alkaline Batteries (Optional Accessory)
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery latch up to release the battery cover
and remove the cover.
3. Insert the three AA alkaline batteries with + and - polarity as shown inside.
4. Reposition the battery cover and press down to secure.
Radio Battery Meter
The radio battery icon shows the radio battery charge level, from full
to
empty.
When the radio has one segment left, the radio chirps periodically or after releasing
(Low Battery Alert).
Removing the NiMH Battery Pack
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery latch up to release the battery cover
and remove the cover.
3. Gently remove the NiMH battery by easing it out.
4. Reposition the battery cover and press down to secure.
Removing the Three AA Alkaline Batteries (Optional Accessory)
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery latch up to release the battery cover
and remove the cover.
3. Remove each alkaline battery by easing each battery out individually.
4. Reposition the battery cover and press down to secure.
Notes:
• Exercise care when removing NiMH or AA batteries. Do not use sharp or conductive
tools to remove either of these batteries.
• Remove the batteries before storing your radio for extended periods of time. Batteries
corrode over time and may cause permanent damage to your radio.
Using the Plug-in Charging Adaptor
The battery plug-in charger (adaptor) provides charging convenience for NiMH batteries in
one or both radios. Charge the NiMH battery overnight (at least 16 hours) before using it
for the first time. After the initial charge, an empty battery is fully charged within 14 hours.
1. Follow the steps above to install a NiMH battery pack.
2. Connect the AC power adaptor plug into the recharging jack at the bottom of the radio.
(The adaptor charges two radios.)
3. Plug the AC power supply into a standard wall outlet.