Motorola B804 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон Motorola B804. Motorola B804 47 сторінок. Dect 6.0 cordless answering system with bluetooth wireless technology
Також для Motorola B804: Посібник із швидкого старту (8 сторінок)
1
GETTING STARTED
WARNING
Do not place your phone in the bathroom or other humid areas.
. CHOKING HAZARD - SMALL PARTS
Not intended for children under 3 yrs.
This product is not intended to be used as a toy or play thing.
Location
When choosing a location for your new phone, here are some important guidelines you should
consider:
• Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens,
heating appliances and direct sunlight.
• Avoid areas of excessive dust, moisture and low temperature.
• Avoid other cordless telephones or personal computers.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
• Never touch non-insulated telephone wires or terminals, unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
HANDSET RANGE
Optimal range is reached when there are no other electrical appliances working within the range
area. Any obstruction between the base and handset will also reduce the range significantly.
SIGNAL STRENGTH
When out of range of the base, the screen shows SEARCHING FOR BASE. If you are on a call,
the line will hang up. Move back within in range. The handset will automatically re-connect to the
base.
Setting up
IMPORTANT
The base must be plugged into the electrical outlet at all times. Do not connect the telephone line
cord into the wall jack until the handset is fully charged. Only use the power adapter and
telephone line cord supplied with the product.
WHICH POWER ADAPTER?
The power adapter with the smaller pin plug is for the base unit and the power adapter with the
bigger pin plug is for the charger unit.
Connecting the base