Motorola D1003 Посібник користувача - Сторінка 20
Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон Motorola D1003. Motorola D1003 26 сторінок. Digital cordless phone
Також для Motorola D1003: Посібник користувача (45 сторінок), Посібник користувача (26 сторінок), Посібник користувача (50 сторінок)
Друкувати сторінку
Intrusion
When an external call is taking place, another handset registered to the base can join in, making
the call a 3-way conference, just by pressing
To enable this, Intrusion must be switched On.
m
d
1. Press
, scroll
to
ADVANCED SET
and press
d
m
2. Scroll
to INTRUSION. Press
.
u
d
3. Scroll
or
to
ON
or OFF.
m
4. Press
to confirm.
>
5. Press
to return to standby.
ECO mode
To reduce the level of power emissions, you can select low power or ECO mode. When the ECO
mode is set to ON, the base transmission power will be reduced.
To turn ECO Mode to
ON
or OFF:
m
d
1. Press
, scroll
to
ADVANCED SET
and press
d
m
2. Scroll
to
ECO MODE
and press
.
u
d
3. Press
or
to highlight
ON
or
OFF
then press
-
A confirmation beep is emitted and the handset display will switch between the handset's
name and
ECO
MODE.
NOTE
When Eco Mode is set to ON, the handset range will be reduced.
20
<
.
m
.
m
.
m
to confirm.
9. Help
Charging
The
icon is not scrolling when the handset is placed on the base
• Bad battery contact – move the handset slightly
• Dirty contact – Clean the battery contact with a cloth moistened with alcohol
• Battery is full – no need to charge
Calls
No dialling tone
• No power – check the connections. Reset the phone: unplug and plug back in the mains
• Batteries are empty – charge the batteries for at least 24 hours
• You are too far from the base – move closer to the base
• Wrong line cable – use the line cable provided
• Line adaptor (when needed) is not connected to the line cord – connect the line adaptor (when
needed) to the line cord
Poor audio quality
The base is too close to electrical appliances, reinforced concrete walls or metal doorframes –
move the base at least one metre away from any electrical appliances
The
icon is blinking
• Handset is not registered to the base – register the handset to the base
• You are too far from the base – move closer to the base
No ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller Line Identification (CLI) service does not work
Check your subscription with your network operator
Phonebook
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory
Display
No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base power supply.
• If LED is not lit up, then try disconnecting and connecting the base power supply.
Registration
Unable to register another handset
• Maximum number of 5 handsets has been reached.
• The display shows SEARCHING. You must unregister a handset in order to register a new one.
Interference
Noise interference on your radio or television
Your base or charger may be too close. Move it as far away as possible.
Help