Motorola CLP series Посібник користувача - Сторінка 31

Переглянути онлайн або завантажити pdf Посібник користувача для Радіо Motorola CLP series. Motorola CLP series 48 сторінок. By wsi
Також для Motorola CLP series: Короткий довідник (2 сторінок), Короткий довідник (2 сторінок), Короткий довідник (35 сторінок), Посібник з усунення несправностей (2 сторінок)

Chapter 5

Radio Cloning

This feature allows you to clone radio settings from one radio to another.

5.1

You can copy the radio settings from the source to another radio.

You can use one of the following unit chargers and cables for cloning:

•

CLP Series Single Unit Charger (SUC) kit part number HKPN4008_ and CLP Series Cloning Cable

kit part number HKKN4026_ (optional accessory).

•

Multi-Unit Charger (MUC) Kit Part Number HKPN4007_ (optional accessory)

A multi-channel radio can be cloned to a single channel radio but only the first channel is cloned. The

MUC does not have to be plugged in for cloning, but both radios require charged batteries.

NOTE: The enhanced CLP software also uses the LED to indicate pass or fail status during

cloning. Green LED during cloning indicates pass status and red LED during cloning indicates

fail status.

5.2

Prerequisites: Cloning radios using Multi-Unit Charger (MUC) kit part number HKKN4026_ (optional

accessory)

•

A fully charged battery on each radio.

•

Two Single-Unit Charger (SUC) Kits.

•

Both radios are turned off.

•

Source radio: Radio to be cloned.

•

Target radio: Radio to which the configuration of the source radio is to be copied.

Figure 12: Cloning the Radio through a Single Unit Charger

Procedure:

1 Unplug any cables such as power supply or micro USB cables from the SUC.

68012000044-ED

Radio Cloning