Motorola GM100 Посібник з експлуатації - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Радіо Motorola GM100. Motorola GM100 28 сторінок. Gm series professional radio

2-2

NOTE

Always use a fresh supply of alcohol and a clean container to prevent contamination by

dissolved material (from previous usage).

3.0

Safe Handling of CMOS and LDMOS

Complementary metal-oxide semiconductor (CMOS) devices are used in this family of radios.

CMOS characteristics make them susceptible to damage by electrostatic or high voltage charges.

Damage can be latent, resulting in failures occurring weeks or months later. Therefore, special

precautions must be taken to prevent device damage during disassembly, troubleshooting, and

repair.

Handling precautions are mandatory for CMOS circuits and are especially important in low

humidity conditions. DO NOT attempt to disassemble the radio without ﬁrst referring to the CMOS

CAUTION paragraph in the Disassembly and Reassembly section of the manual.

4.0

Parts Replacement and Substitution

When damaged parts are replaced, identical parts should be used. If the identical replacement

component is not locally available, check the parts list for the proper Motorola part number and

order the component from the nearest Motorola Communications parts center listed in the "Piece

Parts" section of this manual.

Rigid Circuit Boards

The family of radios uses bonded, multi-layer, printed circuit boards. Since the inner layers are not

accessible, some special considerations are required when soldering and unsoldering

components. The through-plated holes may interconnect multiple layers of the printed circuit.

Therefore, care should be exercised to avoid pulling the plated circuit out of the hole.

When soldering near the 18-pin and 40-pin connectors:

avoid accidentally getting solder in the connector.

be careful not to form solder bridges between the connector pins

closely examine your work for shorts due to solder bridges.

MAINTENANCE