Motorola M110 Вирівнювання - Сторінка 2

Переглянути онлайн або завантажити pdf Вирівнювання для Радіо Motorola M110. Motorola M110 8 сторінок.

(4) Connect the radio anrenna output to an accurate RF power meter that provides a 50-ohm load.

(5) Connect a dc voltmeter from the steering line test point (SL) to ground. Meter impedance should

be 11 megaohms or more.

(6) Key the radio and adjust coil L210 until the voltage reads 7.0 VDC

(7) Select the channel with the lowest transmit frequency. Key the radio and verify that dc voltage is

at least 2.5 VDC

(8) Select any transmit channel. (If radio has the MAB889 slaved RF power option, select any high

power transmit channel).

(9) Key the radio and adjust R453 (HI PWR) for:

Model number

MAU0

MAU1

MAU2

MAU3

(10) Switch through all channels (all high power channels for MAB889). On each channel key the

radio and note the power output.

For MAU0, MAU2 and MAU3 models note tha channel that gives tha minimum power output;

for MAU1 models note the channels that gives

The maximum power output. If more than one channels gives tha same maximum or minimum

power, chose any one of those channels.

(11) Switch through all transmiot channels (all high power channels for MAB889). On each channel,

key tha radio while watching tha dc voltage at Pin 4 of connector P6, or at test point CV on the

command board. Record the number of the channel that gives the greatest voltage and what voltage

is. (If more than one channel gives the same maximum voltage, chose any of those channels). If it

is greater than 10.0 VDC, go to step 14 if not go to step 12.

(12) On the channel that step 11 shoved to have the highest dc voltage, turn R463 fully CCW. Turn

R453 fully CW.

(13) Key the radio. Adjust the voltage limit pot R463 for a dc voltage 2.0 higher than voltage level

recorded in step 11, as measured at Pin 4 of P6 or at test point CV

(14) Set the channel selector to the chennel that was noted in step 10. Key the radio and adjust R453

for:

Model number

MAU0

MAU1

MAU2

MAU3

Power setting

1.0 W

6.0 W

10.0 W

25.0 W

Power setting

1.1 W

5.6 W

10.7 W

26.8 W