Motorola MCS 2000 Інструкція з модернізації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з модернізації для Радіо Motorola MCS 2000. Motorola MCS 2000 11 сторінок.
Також для Motorola MCS 2000: Посібник з монтажу (14 сторінок), Посібник користувача (20 сторінок)
Друкувати сторінку
Reconfiguring Control
Head (Models II and III
only)
Mounting Radio Body
Disconnecting Original
External Loudspeaker
Wiring
disconnecting the loudspeaker built
into the control head when an external
loudspeaker is to be used.
3. If an external loudspeaker is to be connected, unplug connector
on red loudspeaker wire inside control head from control head
circuit card assembly. Cover plug with insulating tape then push
wire back down into control head.
4. Reconfigure control head to remote mount configuration as
shown in the document referred to in step 1.
NOTE:
If the radio body is not being relocated,
skip to the paragraph titled
"Disconnecting Original Loudspeaker
Wiring".
1. In Installation Manual 68P02058U20, refer to section titled
"Control Head Remote Mount Installation".
2. Remove control head from radio body.
3. Reconfigure control head to remote mount configuration as
shown in the document referred to in step 1.
NOTE:
If the radio body is not being relocated,
skip to the paragraph titled
"Disconnecting Original External
Loudspeaker Wiring".
1. Mount radio trunnion, removed from vehicle previously, in the
new location for radio body. Use the four original attaching
screws.
2. Route remote mount power cable (part of retrofit kit) from vehicle
engine compartment to new location for radio body.
NOTE:
The following section describes the
reconfiguration of external
loudspeaker Kit Numbers HSN4024( )
and HSN4025( ). If no external
loudspeaker is to be used, skip to the
section titled "Mounting and
Connecting Control Head".
1. Refer to Figure 2 and on bottom side of radio unplug accessory
plug from accessory connector.
2. Refer to Figure 3, squeeze tabs together, and lift off cover from
accessory plug.
5