Motorola APX 6000 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Портативний радіоприймач Motorola APX 6000. Motorola APX 6000 45 сторінок. Vehicular adapter (va) system compatibility matrix
Також для Motorola APX 6000: Коротка довідкова картка (2 сторінок), Коротка довідкова картка (2 сторінок), Коротка довідкова картка (2 сторінок), Посібник (25 сторінок)
•
United States Federal Communications Commission (FCC), Code of
Federal Regulations; 47 CFR et seq.
•
FCC, OET Bulletin 65.
•
Institute of Electrical and Electronic Engineers (IEEE) C95.1.
•
International Commission on Non-Ionizing Radiation Protection (ICNIRP).
•
Ministry of Health (Canada) Safety Code 6.
•
Industry Canada RSS-102, Australian Communications Authority
Radiocommunications Standard et seq.
•
ANATEL ANNEX to Resolution No. 303 et seq.
RF Exposure Compliance and Control Guidelines and
Operating Instructions
To control exposure to yourself and others and to ensure compliance with the
RF exposure limits, always adhere to the following procedures.
Guidelines
•
User awareness instructions should accompany device when transferred
to other users.
•
Do not use this device if the operational requirements described herein
are not met.
Instructions
•
Transmit no more than the rated duty factor of 50% of the time. To
transmit (talk), push the Push-to-Talk (PTT) button or, for radios equipped
with Voice Activation (VOX), speak into the microphone. The red LED will
illuminate when the radio is transmitting. To receive calls, release the PTT
button, or, for radios equipped with VOX, stop talking. The red LED will
extinguish when the radio stops transmitting. Transmitting 50% of the
time, or less, is important because this radio generates measurable RF
energy exposure only when transmitting (in terms of measuring for
standards compliance).
•
Transmit only when people outside the vehicle are at least the
recommended minimum lateral distance away, shown in Table 1, from the
body of a vehicle with a properly installed antenna. This separation
distance will ensure that there is sufficient distance from a properly
installed (according to installation instructions) externally-mounted
antenna to satisfy the RF exposure requirements in the standards listed
above.
5