Epson TM-H6000II Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Виробник етикеток Epson TM-H6000II. Epson TM-H6000II 12 сторінок. How to connect printer with a wireless adapter
Також для Epson TM-H6000II: Брошура (2 сторінок), Брошура (2 сторінок), Посібник користувача (15 сторінок), Посібник (13 сторінок)
Друкувати сторінку
How to connect an Epson wireless POS printer
setting
Use WEP
key
WEP Key
Channel
Configuring a Computer or Router
There is no way to change the settings on the wireless adapter directly. You first must connect to a computer and then
change any settings using the
wireless settings to work with the adapter to make changes on the wireless adapter to work on your network. After the
changes are made you can reset your network to its original settings.
Tip: It may be less disruptive to configure the wireless adapter using a different computer or network from the one it is to
be installed on.
The wireless adapter defaults to Ad-Hoc mode, with a SSID of EpsonNETIBSS, IP address of 192.168.192.168 and no
encryption.
Configuring a Wireless Router
If you are using a wireless router to connect with the printer:
Configuring a Computer with a Wireless Adapter
If you are using a wireless adapter installed in a computer to connect with the printer:
1. Install the wireless adapter on the computer if not already installed
2. Change the wireless adapter to Ad-Hoc. Open up the Wireless Adapter tab and press Advanced. Then change the
3. Open the Wireless Adapter Properties in the Network Connections of the Windows Control Panel. If the first three
http://www.beaglehardware.com/howtowireless.html[3/4/2011 12:28:11 PM]
Manual
None
None
11
Epson TMnet
Select AD-Hoc mode
Set the subnet to work in the address range of the wireless adapter (192.168.191.xxx if using default value)
Make sure the wireless broadcast is on
Turn off encryption or WEP
Turn off firewalls and filtering
Networks to access to ad-hoc.
numbers of your IP Address are 192.168.192 (assuming the wireless adapter is set at the default IP address of
192.168.192.168) then you do not need to reconfigure your computer's IP Address. If the first three numbers of
IP addresses are assigned on your network.
None / 64-bit / 128-bit
set this if key is used
Channels 1-11. When using Ad-Hoc mode,
set
the channel directly. When using in the
infrastructure mode, it is set automatically.
utility. This means that you must modify your computer's or router's