Epson 7850p - PowerLite XGA LCD Projector Інформаційний посібник про продукт - Сторінка 13

Друкувати сторінку

Epson 7850p - PowerLite XGA LCD Projector Інформаційний посібник про продукт

EPSON PowerLite 7850p Projector

Configuring the Connection

You must configure both the projector and your network card

settings to project wirelessly.

You can configure the projector for either of the following

modes:

Ad Hoc mode: Lets you connect just one PC or laptop at a

time; you need the EPSON 802.11b card and a computer

with a wireless network card.

Access Point mode: Lets multiple users access the projector at

the same time, or trade off control of the projector; you need

the EPSON 802.11b card, a wireless access point, and one or

more computers with wireless network cards.

1. On the EasyMP Network Screen, make sure the Config

button in the lower right corner is highlighted. Then press

Enter on the remote control.

You see a screen similar to the following:

2. Use the

pointer button on the remote control to select

either

Easy connect mode

mode. Then press

Point

3. Use the

pointer button to highlight the

button next to the mode you selected, and press

EPSON PowerLite 7850p Projector

(Ad Hoc mode) or

Access

Enter

Advanced

Enter

You see one of these screens:

4. Select the appropriate settings for your mode.

Use the

highlight a text box, then press

box turns green to indicate you're in input mode. Tilt the

pointer button up to select individual letters in

alphabetical order, or down to select letters in reverse order.

Then tilt the

character position. When done entering a new setting, press

Enter

To enter numbers, press the Num button on the remote

control. The button lights up to indicate that the numeric

keypad is active. Press the

numeric keypad mode. When done entering the setting,

press

Enter

6/03

pointer button on the remote control to

. The outline of the

Enter

pointer button right to move to the next

button again to exit

Num

Ad Hoc

mode

Access

Point

mode