Epson ActionNote 880C Бюлетень підтримки продукту

Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Програмне забезпечення Epson ActionNote 880C. Epson ActionNote 880C 3 сторінки. Product support bulletin(s)
Також для Epson ActionNote 880C: Посібник користувача (17 сторінок), Посібник користувача (47 сторінок), Інформаційний посібник про продукт (11 сторінок), Інструкції з програмування (1 сторінок)

EPSON

7/31/96

Date:

PSB.1996.07.001

PSB No.:

Reference:

SI 960139

Originator:

Authorization:

KAS

AN 866C, AN 880C, and AN 880CX

Affected Product(s):

Subject:

Using Windows NT 3.51 on the ActionNote 866C, 880C, and 880CX Notebooks

The purpose of this document is to provide information on configuring the ActionNote 866C, ActionNote

880C and ActionNote 880CX computer systems to ensure that Windows NT 3.51 will operate properly.

Reason For This Bulletin:

An issue was reported that the unit would lock up if the computer's internal cache was enabled and if the

option "Shutdown and Restart" was selected in Windows NT 3.51.

Configuration Changes:

1. The notebook should have at least BIOS version 1.01T. To see if this FLASH BIOS is installed on the

computer, turn the computer on and watch the screen. The following will appear :

PhoenixBIOS(TM) A486 Ver 1.03,

V1.01T

If it says Ver 1.00B or 1.00C, the system needs the FLASH BIOS upgrade. The FLASH BIOS can be

downloaded from the Epson Forum on CompuServe or the Epson Download Service. To access the

Epson Forum on CompuServe, type in GO EPSON and download the file AN101T.EXE. To access

the file on the Epson Download Service, dial 800-442-2007. The file is located in the

Portable/Notebook Computer Library and the name of the file is AN101T.EXE. If you are unable to

download the file, it is available through the Epson Connection.

2. The hard disk settings in the system SETUP will need to be changed. Normally, the Hard Disk

selection in the system SETUP is set for AUTO hard drive detection. This setting can cause the

issues discussed above for various hard drives. This setting will need to be changed to USER

DEFINED and the parameters of the installed hard drive will need to be entered. For example, if the

TOSHIBA MK1824FCV hard drive is installed, the hard drive setting must be changed to USER

DEFINED and the following parameters need to be entered.

Cylinders:

682

Heads:

S e c t o r s : 6 3

This will allow the system to utilize the Toshiba MK1824FCV hard drive with Windows NT 3.51.

RODUCT

UPPORT

Page 1 of 2

ULLETIN